TREAD ROLLERS: 1-3/8″ dia. x 18 ga. galvanized steel, model 138G with 5/16″ hex.
PRESSURE ROLLERS: 1-3/8″ dia. x 18 ga. galvanized steel, model 138G with 5/16″ hex.
RETURN ROLLERS: 1-3/8″ dia. x 18 ga. galvanized steel, model 138G with 5/16″ hex, adjustable.
BELTING: 2-1/4″ wide “high strength” PVC-150 belt.
CENTER DRIVE: Reversible drive w/ 24″ integral belt take-up.
DRIVE PULLEY: 4″ dia. with 1-3/16″ dia. shaft or 8″ dia. with 1-7/16″ dia. shaft; both crowned and fully lagged.
END PULLEY: 4″ dia., crowned, with 1-3/16″ dia. shaft.
BEARINGS: All pulley bearings are precision, heavy duty, lubricated, ball bearing units with cast iron housings.
SPEED: 60 FPM, constant.
BED: 6″ x 1-1/2″ x 12 ga. channel frame slotted for tread rollers to pop-out. When unit is installed at 7′-0″ elevation or higher, rollers must be retained in conveyor frame. Specify desired elevation. Bed sections attached with couplings and floor supports.
SQUARING RODS: Adjustable rods on underside of bed allow frame to be squared for improved belt tracking and are standard on all units over 30′.
FLOOR SUPPORTS: Optional
MOTOR DRIVE: 1/3 HP, 230/460/3, 60 cycle, ODP right angle gear motor.
ROLLER CHAIN: Drive pulley is driven by No. 50 roller chain for 1-1/2 HP or less and No. 60 chain on larger drives. Chain take-up provided on motor base.
ELECTRICAL CONTROLS: Optional